Heat Tracing in Ammonia Plants
Ammonia plants combine very low temperatures (liquid ammonia storage around -33 °C) with high-temperature duties (reformer and synthesis sections). That spread is what makes tracing specification non-trivial: one project may need both cryogenic-compatible warming and high-temperature process maintenance. This article covers the main tracing duties in an ammonia plant, the refrigerant side and the piping details that cause most commissioning problems.
Tracing duties in an ammonia plant
| Location | Duty | Typical range | Notes |
|---|---|---|---|
| Liquid ammonia storage and transfer | Prevent over-cooling / control boil-off | around -33 °C | Low-temperature cable families, careful material selection |
| Ammonia vaporiser feed lines | Vaporisation support | process dependent | Often steam; electric where steam is unavailable |
| Urea and carbamate lines | Maintain temperature to avoid crystallisation | higher temperature service | Corrosion-resistant components |
| Sample and analyser lines | Prevent condensation and freezing | process dependent | Small lines, high heat loss |
| Fire water and deluge on skids | Freeze protection | +5 °C | Must remain functional while plant runs |
| Instrument air and purge lines | Prevent condensate freezing | +5 to +15 °C | Commonly forgotten in cold climates |
Two temperature worlds in one plant
Designing the ammonia side is different from designing the hot process side, and mixing the two assumptions is a common source of error:
- Low-temperature service: cable jackets and accessories must remain flexible at -40 °C and below; termination methods differ from ambient-temperature practice. Self-regulating cable is generally not the right choice below about -20 °C.
- High-temperature service: mineral-insulated or constant wattage cable, with attention to differential expansion between cable and pipe.
Specific hazards
1. Ammonia attacks many materials
Copper and copper alloys are unsuitable in ammonia service. That removes many standard accessories and forces a check of every component that contacts the fluid — cable jacket, glands, gaskets and labels included.
2. Flammable, toxic and detectable by smell
Ammonia is flammable at higher concentrations and toxic at modest ones. Hazardous area classification and gas detection requirements apply to some areas; tracing equipment rating must match the zone, not the "normal" process area.
3. Cold surfaces need insulation and vapour barriers
The refrigerant side requires closed-cell insulation with a proper vapour barrier; water ingress into insulation destroys its performance and corrodes the pipe. Trace + insulation + vapour barrier form one system.
Control philosophy
- Separate circuits for refrigerant side and process side; one alarm philosophy cannot serve both.
- Sensor placement at the coldest or most exposed point — on ammonia lines that is often a support or a valve body, not a straight run.
- Rate-of-change alarms for critical lines; absolute limits are late warnings.
Commissioning checks
- Insulation resistance on every circuit before and after insulation, with the vapour barrier inspected after closing.
- Verify low-temperature flexibility: check cable and termination ratings at expected minimum metal temperature, not ambient.
- Confirm material compatibility for ammonia service across all wetted and exposed components.
- Test alarms at the control system and confirm that maintenance isolation does not disable tracing for a live area.
- Keep the loop file with as-built routing and set points; plants are modified over decades and the tracing is always hardest to trace afterwards.
In ammonia plants, tracing specification fails more often from material and low-temperature detail than from wattage. Get the environment right first, then the heat.